Ocad 10

[Kris]

I've been doing some mapping using the free OCAD 10 demo but now I've run out of time... I've managed to get access to OCAD 8 from my club but can't open the OCAD 10 file. Does anyone know if theres a way to convert the OCAD 10 file to an OCAD 8 file? I'm not hugely wanting to do it all over again. Thanks.

[mappingmum]

In OCAD 10 you need to save the file as an OCAD 8 file.

[Kris]

The demo only allows you to save as OCAD 10 file which is my problem...

[mappingmum]

Ah right! You need to ask the audience then for a volunteer who has the full version. I'm not that up-to-date, else I'd do it for you.

[Big Jon]

I've avoided OCAD 10 - seemed like a lot of money for very little improvement in the functions I use.
I guess I might have to buy it if and when some major event demands files in 10 format.

[awk]

I've avoided OCAD 10 - seemed like a lot of money for very little improvement in the functions I use.

It's a lot of money full stop.

[RJ]

Make contact with OCAD themselves and ask them to convert your file. I'm sure they would.

[Big Jon]

"Make contact with OCAD themselves and ask them to convert your file. I'm sure they would."
And probably charge for the work!